Interlogix Concord 4 REV C Installation Manual Manual do Utilizador

P/N 466-2371 • REV C • NOV12 1 Concord 4 Installation Guide Content Contact information 1 Description 1 Panel location 2 Power and wire len

10 Concord 4 Installation Guide Table 11: SIA setting requirements Function Default setting Required setting Exit extension On On Duress code Disab

Concord 4 Installation Guide 11 Note: The installer must verify the compatibility between this panel and the central station receivers being used.

2 Concord 4 Installation Guide Phone line connection Allow s panel to communicate w ith central monitoring station and/or pagers. Note: The total cu

Concord 4 Installation Guide 3 Device Max. wire length to panel Standby mA draw Alarm mA draw Interrogator AVM 22 ga.: 110 ft. 18 ga.: 260 ft. 45 m

4 Concord 4 Installation Guide Grounding the panel For maximum protection from lightning strikes and transients, connect the enclosure to earth grou

Concord 4 Installation Guide 5 Only when the display shows SYSTEM PROGRAMMING can you advance to tier 2 programming menus. Press B or # to advance

6 Concord 4 Installation Guide are adding (learning) into the panel memory to send a signal to the panel. 7. To add another sensor to the same s

Concord 4 Installation Guide 7 Sensor group characteristics Table 10 below shows what the sensors on your Concord 4 system do. Every sensor is as

8 Concord 4 Installation Guide Number Name Application Alarm Delay Restoral Supervisory CS report Chime (level) Active (level) 19 Delayed interior In

Concord 4 Installation Guide 9 Specifications Pow er requirements Class 2, 16.5 VAC, 40 VA, 60 Hz (600-1023 or 600-1024) Rechargeable battery: 12 VDC