Interlogix Concord Express Installation Manual Manual do Utilizador descarregar pdf (Página 30)

Chapter 1

24 Concord Express Installation Instructions

Figure 18: Connecting the power transformer

Powering Up the Panel

Note: Without AC power, shutdown will occur if battery voltage falls below 10.2

VDC.

After installing SnapCards and wiring all devices to the panel, you are ready to

apply AC and backup battery power to the panel.

To power up the panel:

1. Connect the red and black battery leads (included with panel) to the lugs

located in the upper-left area of the panel circuit board (see Figure 19 below).

Figure 19: Connecting the backup battery

2. Connect the battery leads to the battery terminals as shown.

3. Plug the transformer into an outlet that is not controlled by a switch or ground

fault circuit interrupt (GFCI).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 116 117

Sem comentários

Interlogix Concord Express Installation Manual Manual do Utilizador Página 30