Interlogix Simon XT Installation Manual Manual do Utilizador descarregar pdf (Página 32)

26 Simon XT Installation Manual

3. Disconnect the green and red premises phone jack wires from the Telco block

D and splice them C to the four-conductor cable A black and white (or yellow)

wires. Use weatherproof wire connectors for these splices.

4. Connect the four-conductor cable A green and red wires to the Telco block D

TIP (+) and red to RING (–) posts.

5. Connect the phone cord E included with the panel to the RJ31X B and the

panel LINE jack.

Figure 8: Full line seizure wiring with RJ-31X

Full line seizure wiring with one premises phone

If a single phone is all that exists on the premises, full line seizure can be

accomplished without an RJ31X (Figure 8 above).

1. Disconnect the phone from the premises phone jack and plug it into the panel

PHONE jack A. This jack is disconnected automatically whenever the panel

reports.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 73 74

Sem comentários

Interlogix Simon XT Installation Manual Manual do Utilizador Página 32