Interlogix NX-4V2 Installation Guide Manual do Utilizador descarregar pdf (Página 7)

UL365

Police station connected burglar alarms

UL609, CAN/ULC-S303- Mercantile, police station connect with

-C M91 basic line security requires NX-003

enclosure

UL985, CAN

M89

/ULC-S545- Household fire

UL1023, ORD-C1023-

1974

Household burglary

UL1610 Central station burglar alarm unit

UL16 ystem units 35 Digital alarm communicator s

UL1637 Home health care signaling

Whe nderwriters

observed:

•

4T-12 or equivalent.

• ed. The auxiliary outputs

utes for commercial burglary, four minutes

test

l burglary

•

ted.

• assing must be disabled.

•

n UL listed

tions.

• nabled.

0 seconds.

• ttery, limit

• ery,

•

• ted

0,12,13,14; Silent Knight 9000 - 2,12; FBI -

and 13.

0 percent in the area of coverage, and similar

, and so

• ate the siren.

, the

-1215W,

sensor: S1224MC strobe series;

wire detectors): ESL: 500N

series; 449CTE series; 521 series; 541 series

4TR;

ises or area of

the building in which the alarm system is installed or

e service

antile alarm

n installing an NX-4V2 in compliance with U

Lab

oratories, the following instructions must be

• Initiating and indicating devices must be rated at 11.5 to

12.4 VDC residential, 12.0 VDC commercial.

Force arming and auto arming must not be enabled.

For residential fire applications, the indicating devices

shall be a Wheelock 3

• The listen in feature shall not be enabled.

The siren/bell test must be enabl

controlling the audible device require a minimum cutoff

time of 15 min

for residential applications, or 30 minutes for commerci

burglary for Canada.

• For residential fire installations, the dynamic battery

time cannot exceed four hours.

• Ringback must be enabled on UL commercia

installations.

On commercial burglary installations, the fire initiating

circuits must not be connec

• The entry guard feature must be disabled.

Group byp

• Delay before dial seizure must be set to 0.

Total current draw from auxiliary power connections at

terminal positions POS, AUX PWR, and SMOKE PW

must not exceed 400 mA.

• Remote downloading must not be used o

systems.

• For residential burglary applications, the maximum entry

and exit delay times are 45 and 60 seconds respectively.

The exit delay time must not exceed 60 seconds for

commercial burglar alarm applica

• The keyswitch option must not be used.

The telephone line monitor must be e

• The telephone line cut delay must not exceed 9

• The 24-hour communicator test transmission is required.

For 24-hours of standby power using a 7.0 Ah ba

auxiliary power load to 140 mA.

For 24-hours of standby power using a 17.2 Ah batt

limit auxiliary power load to 400 mA.

The silent keypad option must not be enabled.

UL has only verified compatibility with the following lis

DACRs and formats: Sure-Gard SG-MLR2-DG:

2,9,1

CP220FBI, 13; and Ademco 685: 2,11,12,

• For burglary installations, cross zoned detectors must

overlap 10

coverage areas must be used. For example, interior

protection is cross zoned with interior protection

on.

Expander trouble must activ

• For UL 1637, expander trouble must activate the keypad

sounder.

• If the late to close/early to open feature is enabled

op ning and closing reports must be enabled.

• For Canadian installations, the class II transformer secure

tab must not be employed.

e• Th four-wire smoke detector employed must be rated to

operate over the voltage range of 11.5 to 12.4 V.

• Compatible listed devices: (special applications):

• Bell output (sirens): Wheelock models: NS

NS-121575W, NS4-1215W, NS4-121575W, AS-1215W

AS-121575W

• Horn/strobe system

12 4MC Horn/strobe series; H12/24 Horn series

• Smoke output (four-

• System sensor models: 2112/24R; 2112/2

2112/24AT; 2112/ATR; 2112/24AITR; 4WTA-B; 4WTR-B;

4WTAR-B; 4WITAR-B

• Detection systems: F220-B6C; D273 series; Hochiki:

SBC-4/12, 4/12W

Additional UL 609 installation requirements

he alarm housing for a mercantile alarm system without a

remote alarm transmission connection shall be mounted on the

outside of the building, visible from a public street or highway.

It shall be accessible for examination and repair. It shall also

be located not more than four stories above the street level

unless:

a) A second alarm sounding device and housing, intended for

outside service is mounted adjacent to the prem

b) A second alarm sounding device, intended for insid

is mounted within the premises.

In either case, the outside alarm sounding device and housing

may be mounted as high as the seventh floor.

Additional UL 365 installation requirements

In a mercantil

e burglar alarm system, a merc

sounding device located within a building, but outside the

NX-4V2 Control Panel Installation Instructions 7

1 2 3 4 5 6 7 8 9 10

Comentários a estes Manuais

Sem comentários

Interlogix NX-4V2 Installation Guide Manual do Utilizador Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Painel de controlo Interlogix NX-4V2 Installation Guide